Dyna - Acrylic Protective Sealant DynaMatrix HB-2 for Pavers and Slabs 18.9 L
Dyna coatings in Clear. The right piece to finish your installation.
Product details
Dyna coatings in Clear. The right piece to finish your installation.
DYNA HB-2 Protective Sealant for Interlocking Pavers and Slabs is a high end Acrylic Sealant specifically designed to protect and enhance the look of Interlocking Concrete Pavers and Slabs. It penetrates deeply into the substrate for a maximum protection against most stains (oil, gasoline, gum, tar, rubber, rust, etc.) while rendering a clear wet look finish.
Carefully blended with thermoplastic resins and refined solvents, DYNA HB-2 Protective Sealant is suitable for use in all weather conditions. It will offer you a rich and durable finish that withstands heat, sun, salts, frost and all aggressive weather elements. It will not peel, delaminate or yellow.
Key features
- Adequate Solids Content for Interlocking Concrete Pavers (20 %)
- Clear Satin Look Finish, enhances the colors of the treated surface
- Penetrates deeply for better and more durable protection against stains
- Reduces damages due to freeze-thaw cycles
- Resists all weather elements (sun, rain, frost, heat, salt, etc.)
- Will not trap moisture after fully cured
- Satin finish
- Brand
- Dyna
- Collection
- DynaMatrix HB-2
- Colour
- Clear
- Browse category
- Setting Materials
- Browse sub-category
- Coatings
- Finish
- Satin
- SKU
- 4441-18.9
- Pieces per box
- 1
- Per skid
- 36
- Indoor use
- Yes
- Outdoor use
- Yes
- Use on
- Colored porous concrete surfaces such as: Interlocking Concrete Pavers, Stamped or Patterned Concrete, Exposed Aggregate Surfaces and Natural and decorative veneers
- Hardness
- Tukon at 180°F = 10 · at 300°F = 12.1
- Chemical resistance
- Resists airborne pollutants, oil, yellowing, de-icing salt, acid rain, chlorine
- TVOC emissions
- < 395 g/L
- Certifications
- LEED Point Contribution: MR Credit 5, Regional Materials (Up to 2 Points)
- Coefficient of friction
- > 0.65 Wet · > 0.75 Dry (ASTM F1679)
- Cure time
- 48 hours
- Shelf life
- 5-Year
- Storage
- Keep in storage at temperature between 10°C (50°F) and 22°C (72°F)
Installation — Glue-down
- Acclimate the material and make sure the subfloor is clean, dry and flat.
- Spread the recommended adhesive with the correct-notch trowel; work in small sections.
- Set each piece into the wet adhesive and roll the floor to ensure full transfer.
- Keep traffic off until the adhesive fully cures (check the adhesive label).
Care & maintenance
- Sweep or dry-mop regularly; damp-mop with a pH-neutral cleaner.
- Wipe spills promptly and use felt pads under furniture.
No reviews yet for this product. Be the first to review it after your purchase.