Dyna - Acrylic Protective Sealant DynaMatrix WB-2 for Pavers and Slabs 3.78 L
Dyna coatings in Clear. The right piece to finish your installation.
Product details
Dyna coatings in Clear. The right piece to finish your installation.
DYNA WB-2 SEALANT FOR PAVERS AND SLABS is a high end Acrylic Sealant specifically designed to protect and enhance the look of Interlocking Concrete Pavers, Slabs, Exposed Aggregate and Terrazzo Floors. It penetrates deeply into the substrate for a maximum protection against most stains (oil, gasoline, gum, tar, rubber, rust, etc.) while rendering a clear satin finish.
Carefully blended with thermoplastic resins, DYNA WB-2 SEALANT is suitable for use in all weather conditions. It will offer you a rich and durable finish that withstands heat, sun, salts, frost and all aggressive weather elements. It will not peel, delaminate or yellow. Low VOC, blush resistance and low odor. Highly abrasion resistant.
Key features
- Low VOC, low blushing resistance, low odor
- High blush abrasion resistance
- Clear Satin Look Finish, enhances the colors of the treated surface
- Penetrates deeply for better and more durable protection against stains
- Reduces damages due to freeze-thaw cycles
- Resists all weather elements (sun, rain, frost, heat, salt, etc.)
- Satin finish
- Brand
- Dyna
- Collection
- DynaMatrix WB-2
- Colour
- Clear
- Browse category
- Setting Materials
- Browse sub-category
- Coatings
- Finish
- Satin
- SKU
- 4510-3.78
- Pieces per box
- 1
- Indoor use
- Yes
- Outdoor use
- Yes
- Use on
- Colored porous concrete surfaces such as: Interlocking Concrete Pavers, Stamped or Patterned Concrete, Exposed Aggregate Surfaces and Natural and decorative veneers
- TVOC emissions
- < 95 g/L
- Certifications
- Meets regulations, including OTC, Maricopa County, and California (CARB), EPA, SCAQMD, NOTC
- Shelf life
- 5-Year
- Storage
- Keep in storage at temperature between 10°C (50°F) and 22°C (72°F)
Installation — Glue-down
- Acclimate the material and make sure the subfloor is clean, dry and flat.
- Spread the recommended adhesive with the correct-notch trowel; work in small sections.
- Set each piece into the wet adhesive and roll the floor to ensure full transfer.
- Keep traffic off until the adhesive fully cures (check the adhesive label).
Care & maintenance
- Sweep or dry-mop regularly; damp-mop with a pH-neutral cleaner.
- Wipe spills promptly and use felt pads under furniture.
No reviews yet for this product. Be the first to review it after your purchase.